|
Clean frpDesign Solutions wall or ceiling panels on a regular basis so that soil and dirt will not build up. A mild non-abrasive cleaner is recommended.
A 5% to 10% trisodium phosphate water solution not to exceed 130°F (55°C), can be used. If trisodium phosphate is not available, use a 5% to 10% solution of household automatic dishwasher detergent. If a USDA or FDA approved cleaner is required, a neutral cleaner (pH range 6.5 - 7.5) is preferred. Follow the manufacturer's directions. Do not use a cleaner or stain remover that contains chlorinated hydrocarbons or aromatic hydrocarbons. Do not use abrasive cleaners.
frpDesign Solutions panels can best be cleaned with a sponge or soft brush. Wire brushes or other abrasive tools or pads will scratch the surface. Apply the cleaner, working it across the surface in a scrubbing or circular motion. Rinse thoroughly to remove all traces of the cleaner, otherwise a film will build up giving the panel a dull, dirty appearance. When using a specialty cleaner, follow the manufacturer's instructions. Test a small area before applying over the entire surface.
To clean hard water deposits use a 10% solution of acetic acid in COLD water. Use the same cleaning procedures outlined above. If the panel surface becomes dull or abraded, complete cleaning may not be possible.
You will need Adobe® Acrobat Reader to view the data downloads.
If you do not have this software you may download it for free at Adobe.com .
Disclaimer
The facts stated above and the recommendations made herein are based on our own research and are believed to be accurate. No guarantee of their accuracy is made however, and unless otherwise expressly provided in written contract, the products discussed are sold without conditions or warranties, expressed or implied. Purchasers should make their own tests to determine the suitability of such products for their particular purpose. Nothing contained herein shall be construed to be a recommendation to use or as a license to operate under, or to infringe any existing patents. Phone: 1.800.435.0080 or 1.815.467.8600
Email: salesbp@cranecomposites.com |
